Menu
Doris Irwin headed for the century mark

Doris Irwin headed for the century …

Doris Irwin has seen a lo...

Hancock Whitney Bank gives $25,000 for Hurricane Michael relief

Hancock Whitney Bank gives $25,000 …

The City of Marianna has ...

Public tours Endeavor for first time since its closure as Dozier

Public tours Endeavor for first tim…

Arthur G. Dozier School f...

Kids and Cars

Kids and Cars

During the thirties, Moth...

How to repair scratched wood floor

How to repair scratched wood floor

Touch up kits are availab...

First baby of 2019 arrives at Jackson Hospital New Year’s Day

First baby of 2019 arrives at Jacks…

The first baby of the New...

County starts 2019 with full agenda

County starts 2019 with full agenda

The Jackson County Commis...

Something to Cook About The Cornfields of Donbridge

Something to Cook About The Cornfie…

The first snowflakes of f...

How to install plank vinyl flooring

How to install plank vinyl flooring

Installing self-sticking ...

How to install ceramic tile over an existing floor

How to install ceramic tile over an…

Before you can install ne...

Prev Next

How-to replace a toilet

  • Written by  Danny Lipford
How-to replace a toilet

Whether a toilet is being replaced or just temporarily removed to allow flooring repairs or replacement, the process is pretty much the same.

First, turn off the water supply beneath the tank; then flush the toilet to release the water from the tank. Pouring a bucket of water into the bowl will create a vacuum to force out most of what remains there.

Now you can disconnect the water supply line from the bottom of the tank before removing the nuts from the closet bolts on each side of the base. This frees the toilet so you can lift it straight up and out.

After you scrape the old wax ring off of the toilet flange, you’re ready for the next step. That starts with a new wax ring positioned on the flange. The protruding lip on the ring goes down inside the drain pipe under the flange.

Then we add drinking straws to extend the height of the closet bolts and make it easier to lower the new toilet into position over them.

When the toilet and bolts are in position, press down on the toilet to compress the wax ring. Now you can remove the straws and add the plastic cap washer, metal washer and nut to the closet bolts. The nuts should be snug but not too tight or they might crack the porcelain base.

After the plastic caps are put in place, you can connect the water supply line and turn on the water to complete the project.

 Watch the video for details.

For more information, visit TodaysHomeowner.com.

Write a comment...
awesome comments!
back to top