Menu
Tips For Painting A Garage Floor

Tips For Painting A Garage Floor

Before painting a garage ...

Hurricane Michael doesn’t stop MHS art students

Hurricane Michael doesn’t stop MHS …

The MHS Art Department ha...

Pilot Flying J and Johnsonville feeding Jackson County

Pilot Flying J and Johnsonville fee…

The good news continues f...

Greenwood Supermarket and Deli up in flames Tuesday night

Greenwood Supermarket and Deli up i…

The Greenwood Supermarket...

Tips for painting your house

Tips for painting your house

Painting the outside of y...

Deeanna Golden – teaching from the heart

Deeanna Golden – teaching from the …

Deeanna Golden is a veter...

Jackson County Sheriff’s Office relocating due to damage

Jackson County Sheriff’s Office rel…

In a called meeting of th...

Voters turn out in record numbers to cast their ballots

Voters turn out in record numbers t…

Although Jackson County w...

How to replace damaged eave fascia boards

How to replace damaged eave fascia …

The eaves on a house are ...

Davie Police going above serving and protecting

Davie Police going above serving an…

Jackson County has truly ...

Prev Next

How-to remove & replace wood decking

  • Written by  Danny Lipford
How-to remove & replace wood decking

Wooden decking that has rotted or deteriorated over time will need to be replaced. Start by using a hammer and pry bar to remove the old deck boards. You can also insert a long board between the decking and joists to pry the old deck boards loose.

After all the old decking and nails have been removed, pull a string or extend a straight board on edge across the floor joists to make sure the joists haven’t sagged. Replace or shim up any sagging joists before installing the new decking.

Align the first deck board perpendicular to the floor joists and overhanging the outside edge of the deck. Screw the board in place using 3” long, rust resistant deck screws.

Pressure treated deck boards which have been kiln dried after treatment (KDAT) will expand slightly in width after installation, so use an 8-penny nail as a spacer to leave a 1/8” gap between the boards.

Boards that haven’t been kiln dried after treatment and are still wet with preservative will shrink slightly when they dry, so butt them closely together when attaching.

To straighten a crooked board, attach one end of the board to the deck joists, and then pry the other end into place before securing it.

Leave the deck boards longer than the deck, so they hang over the outer edge of the deck by several inches or more. After all the deck boards have been attached, pop a chalk line an inch or so past the end of the deck foundation and use a circular saw to cut the decking to the finished length.

 Watch the video for details.

For more information, visit TodaysHomeowner.com.

Write a comment...
awesome comments!
back to top